Klassic Keyless GM A-Body 2 Door (1964-1969) Keyless Entry System

Home > Keyless Entry Systems >

Klassic Keyless GM A-Body 2 Door (1964-1969) Keyless Entry System with Trunk Release

Alternative Views:

List Price: $399.95

Price: $394.95

Savings: $5.00

Availability: Usually Ships in 1 to 2 Business Days
Part Number: 27-01101-23

Qty:

Description

Replacement Parts

1964-69 GM A-Body 2 Door Keyless Entry Kit with Power Trunk Release

Buick: Special, Skylark, GS
Chevrolet: Chevelle, Malibu, Malibu SS
Oldsmobile: F-85, Cutlass, 442, Hurst Olds
Pontiac: Tempest, Lemans, GTO
1964 1965 1966 1967 1968 1969

This system DOES NOT fit 1964-65 Buick Special, Skylark, GS

Keyless Entry for your classic car

Klassic Keyless has engineered a system that will retro-fit your classic bringing full modern day convenience of remote door locking & unlocking to your classic A-Body. Full color, step-by-step instruction manual will walk you through the installation process.

This system DOES NOT work for vehicles with Shaved Door Handles

Remote Vehicle Entry System Includes:

Keyless entry module with on-board relays for a clean installation:
(2) Three button remote controls
(2) Door lock actuators with 15 lbs. of pulling force & built-in overload protection
(2) Actuator mounting brackets
(2) Rubber door jamb boots
(2) Actuator connecting rods and clips, wire harness, full color step by step instruction manual, and all necessary hardware.

Trunk Release:

INCLUDED: In addition to the parts listed above, you will also receive: One Power trunk latch, wire and wire loom, full color step by step instruction manual, trimming template, and all necessary hardware. Our Power Trunk Latch option allows you to be able to open the trunk by using the keyless entry remote but also retains the factory lock cylinder and key operation. This kit comes with everything needed to replace your factory manual trunk latch with our upgraded power latch and hook it up to your new keyless entry system. Please note that some vehicles do require the installer to trim some metal to enlarge the opening for the new power latch. This trimming does not affect the mounting of the original latch should you decide to reinstall it in the future. In addition to the tools shown above, you may need a die grinder and metal burr to enlarge the hole for installation.