Klassic Keyless GM X-Body 2 Door (1968-1974) Alarm System with Keyless Entry

Home > Alarm Systems >

Alarm System with Keyless Entry for GM X-Body 2 Door (1968-1974)

Alternative Views:

List Price: $299.95

Price: $289.95

Savings: $10.00

Availability: Usually Ships in 1 to 2 Business Days
Part Number: 32-01602-22

Qty:

Description

Replacement Parts

1968-74 General Motors X-Body 2 Door Alarm System with Keyless Entry

Buick: Apollo
Chevrolet: Chevy II, Nova, Nova SS
Oldsmobile: Omega
Pontiac: Ventura (Including 1974 GTO)
1968 1969 1970 1971 1972 1973 1974

Alarm with Keyless Entry for your classic car

Klassic Keyless has engineered a system that will retro-fit your classic bringing full modern day convenience and security from a full featured alarm system with remote door locking & unlocking to your classic X-Body. Full color, step-by-step instruction manual will walk you through the installation process.

Alarm System Includes:

Alarm module with on-board relays for a clean installation:
(2) Two button remote controls
(2) Door lock actuators with 15 lbs. of pulling force & built-in overload protection
(2) Actuator mounting brackets
(2) Rubber door jamb boots
(2) Actuator connecting rods and clips
Multi-tone siren
Dual stage impact sensor
Starter kill relay
Dashboard mounted flashing LED
Pin switches and mounting brackets for hood and trunk protection
wire harness, full color step by step instruction manual, and all necessary hardware.

To add Power Trunk Release Option - (Purchase part number 32-01602-23)

32-01602-23: In addition to the parts listed above, you will also receive: One Power trunk latch, wire and wire loom, full color step by step instruction manual, trimming template, and all necessary hardware. Our Power Trunk Latch option allows you to be able to open the trunk by using the alarm system remote, but also retains the factory lock cylinder and key operation. This kit comes with everything needed to replace your factory manual trunk latch with our upgraded power latch and hook it up to your new alarm system. Please note that some vehicles do require the installer to trim some metal to enlarge the opening for the new power latch. This trimming does not affect the mounting of the original latch should you decide to reinstall it in the future. In addition to the tools shown above, you may need a die grinder and metal burr to enlarge the hole for installation.